Arducam CSI-HDMI Cable Extension Module for Raspberry Pi Camera

Overview
A CSI-to-HDMI adapter set for you to break the length limitations of the MIPI CSI-2 interface and put your Pi cameras up to 3~5 meters away from an RPI.

The kit works out of the box with any of the following cameras:

Official camera module V1/V2/V3/HQ
Arducam OV5647/IMX219/IMX477 Series
Arducam 16MP Series
Arducam 64MP Series
Arducam Jetson Camera Series
No extra software/configuration is needed.
We also have another kit if you want longer connections over CSI 2.

Note: HDMI cables can be up to 3~5 meters depending on the backend processer, camera, and the HDMI cable specs. For longer than 5 meter application, you are recommended to use the Arducam ethernet extension kit (SKU: U6248)

Features

Support NVIDIA Jetson and Raspberry Pi 5, 4B, Pi 3B+, Pi 3B, Pi 2, Model A/B/B+, Pi Zero
Supported for Raspberry Pi Camera Module 3(12MP IMX708), Raspberry Pi HQ Camera (12MP IMX477), Raspberry Pi camera V1 (5MP OV5647) and raspberry pi camera V2 (8MP IMX219)
No extra software/configuration is needed.
HDMI cables can be up to 3~5 meters.
Reserved microphone and headphone jack for audio or GPIO signals
Three additional solder pads are available (same signals as a headphone jack)
Reliability: Way more durable than FPC cables when it is folded or twisted or under negative environmental factors such as moisture, humidity and temperature changes.
Size: 27.63 x 25.00mm

Packing Including

2pcs Arducam CSI to HDMI Cable Extension Module
2pcs 60mm 15pin FPC cables
2pcs 73mm 22pin FPC cables
4sets M2 screw

Note
Make sure to use high-quality HDMI v2.1 cables.
Please be sure to use a high-quality HDMI cable, which allows the camera to run 3-5 meters, greatly extending the usage of the Pi camera.